HSM Shredstar S5 Operations Instructions download pdf (Page 8)

8 02/2011

english

• Set the sliding switch for automatic

operation to "ON/AUTO".

• Feed in the paper to be shred-

ded, however, never feed in

more than 5 sheets at a time.

h The cutting device starts auto-

matically, pulls in the paper and

shreds it.

h When the feed opening is

clear of paper again, the cutting

device switches off.

• The cutting device runs constantly if

you set the sliding switch to "FWD".

REVFWDON/AUTO

REVFWDON/AUTO

4 Operation

Paper jam

• Set the slider switch to "REV".

Pa per is pus hed out.

• Set the slider switch to "ON/AUTO"

again.

• Do not feed in too many sheets at

once.

Shredded material container

Check the level in the shredded material contai-

ner and empty it in good time, as otherwise the

function of the cutting device could be impaired.

For all other malfunctions, check whether the

cutting head was correctly positioned on the

shredded material container before contacting

our customer service. If the motor was over-

loaded, let the shredder cool down for 15 to

20 minutes before using it again.

REVFWDON/AUTO

5 Troubleshooting

Switch off the shredder and pull out the mains

plug.

When cleaning only use a soft cloth and a mild

soap-water solution. However, no water must

enter the equipment.

6 Cleaning

7 Disposal / Recycling

Electrical and electronic old devices

contain a variety of valuable materi-

als, but also hazardous substances

which were required for function and

safety. Incorrect disposal or handling

can be dangerous to your health and

the environment. Never dispose of old devices

in the household waste. Observe the current

applicable regulations and use the collection

points for returning and recycling electric and

electronic devices. Dispose of all the packaging

materials also in an environmentally-responsi-

ble way.

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 83 84

Comments to this Manuals

No comments